TRAXXAS

Stub axle assembly, front, outer, extreme heavy duty (1) (left or right) (assembled with internal-splined half shaft)

Stub axles, rear, heavy duty (2)/pins (2)

Half shaft, internal splined (steel-spline constant-velocity) (1)

Bulkhead, rear

Body mount (1)/ body mount post (2)/ body post extensions (2) (front or rear)

Half shaft, external splined (steel-spline constant-velocity) (1)

Gear set, differential (output gears (2)/ spider gears (2)/ spider gear shaft, carrier support)

Shock tower, front

Wing, Rustler® 4X4 (green)/ 3x8 FCS (3)

Skid plate, roof (body) (green)/ 3x12 CS (4)

Stub axles, front, heavy duty (2)/ yokes (2)/ pins (4)

Shock tower, front

Stub axle assembly, rear, outer, extreme heavy duty (1) (left or right) (assembled with internal-splined half shaft)

Half shafts, heavy duty (external splined (2)/ internal splined (2))/ metal u-joints (4)

Springs, front (progressive, +10% rate, pink) (2)

Cover, gear/ motor wire hold-down clip

Ring gear, differential/ pinion gear, differential (rear)

Drag link, machined 6061-T6 aluminum (green-anodized)

Driveshaft, center, 6061-T6 aluminum (red-anodized)

Driveshaft, center, 6061-T6 aluminum (blue-anodized)

Gear clutch, complete (high stall)

Driveshaft assembly, front, heavy duty (1) (left or right) (fully assembled, ready to install)/ screw pin (1)

Spur gear, 50-tooth (0.8 metric pitch, compatible with 32-pitch) (for Slash 4x4 center differential)

Driveshaft, center, 6061-T6 aluminum (orange-anodized) (189mm)

Gear, 24-T pinion (1.0 metric pitch) (fits 5mm shaft)/ set screw (for use only with steel spur gears)

Gear, 22-T pinion (1.0 metric pitch) (fits 5mm shaft)/ set screw (for use only with steel spur gears)

Gear, 18-T pinion (1.0 metric pitch) (fits 5mm shaft)/ set screw (for use only with steel spur gears)

Body mount (1)/ body mount post (2) (front)