Traxxas

Motor, counter-clockwise (high output, black connector) (1)

Distribution block, Pro Scale® Advanced Lighting Control System

Power Module, Pro Scale® Advanced Lighting Control System (includes Mount, Communication Cables, Hardware)

Sensor, temperature and voltage (short)

Sensor, temperature and voltage (long)

Distribution block, LED light set

Battery straps (225mm) (4)

Connector, wiring harness (EZ-Start® and EZ-Start® 2)

Reverse installation kit (includes all components to add mechanical reverse (no Optidrive®) to T-Maxx® 3.3) (includes 2060 sub-micro servo)

Motor (EZ-Start®)

Mounting plate, electronic speed control/receiver box (for installation of XL-5/VXL and waterproof receiver box into Stampede®)

Seal kit, receiver box (includes o-ring, seals, and silicone grease)

Main chassis (black) (164mm long battery compartment) (fits both flat and hump style battery packs) (use only with #3626R ESC mounting plate)

Plug Adapter (For TRX® Power Charger to charge 7.2V Packs)

Charger, EZ-Peak® Plus, 4 amp, NiMH/LiPo with iD® Auto Battery Identification

Traxxas connector, 4s (male) (2) - FOR ESC USE ONLYFOR ESC USE ONLY The Traxxas 4s connector adds single 4s LiPo compatibility to the VXL-6s speed ...

Battery, Series 3 Power Cell iD®, 3300mAh (NiMH, 7-C hump, 8.4V)

Rudder pushrod, assembled/ servo horn/ 3x18mm BCS (stainless) (1)/ 3x15mm CS (stainless) (1)/ 3x6mm CS (stainless) (1)/ NL 3.0 (1)

Plastic rod ends (8) (1/6 and 1/5 scale)/ hollow ball connectors (8) (6-black, 2-silver)

Motor, clockwise (1)/ motor, counter-clockwise (1)

Water cooling jacket, motor

LED lights, rear harness (6 red lights), Summit (1)/ wire clip (1)

Radio tray with RPM mount/ radio tray retainer (2)/ stuffing tube clamp/ 4x16mm BCS (stainless) (2)/ 4x10mm BCS (stainless) (2)

Plate, motor (for single motor installation, use with gear cover #5677R)

Cover, gear/ 3x8mm CS (1) (for single motor installation, use with motor plate #5690X)

Plate, motor

Bumper, rear (for use with mid-mounted RX battery)

Servo horns, steering and throttle (for non-Traxxas® servos (Hitec, JR, KO, Airtronics))

Reverse installation kit (includes all components to add mechanical reverse (no Optidrive®) to Revo®) (includes 2060 sub-micro servo)

Servo horns, steering and throttle (for non-Traxxa®s servos (Hitec, JR, KO, Airtronics))

Cover plate, steering servo/ 3x8mm BCS (4)

Control box battery cover with belt clip (EZ Start 2)

Charger, AC, 2 amp NiMH peak detecting (5-7 cell, 6.0-8.4 volt, NiMH only)

Foam battery securing block

Tray, radio/ drive shaft mount with pressure fitting