Traxxas

Dual cooling fan kit, low profile (with shroud) (fits #3491 motor)/ 3x16 CS (8)

Battery/charger completer pack (includes #2970 iD® charger (1), #2872X 5000mAh 11.1V 3-cell 25C LiPo iD® battery (1))

Servo Horn, Steering, 6061-T6 Aluminum (Red-Anodized)

LED Light Set, Ford Raptor R (contains Front Bumper with LED Light Bar and Headlights Harness) (fits #10111 Series Bodies)

Motor, 2000Kv 77mm, Brushless (with 6.5mm Gold-plated Connectors and High-efficiency Heatsink)

TRX-4M™ iD® charging port, 2-amp (for charging #2821 2-cell LiPo battery with Traxxas® EZ-Peak® iD chargers)

LED light kit, 1/16 E-Revo® (includes power supply, front & rear bumpers, light harness (4 clear, 4 red), wire ties)

Battery hold-down/ battery compartment spacers/ foam pads

Connector, 25.2 volt to 14.8 volt jumper (allows a Traxxas® dual-battery 25.2 ESC to run on a single 14.8V battery pack)

Heat sink, Titan® 87T motor (6061-T6 aluminum, green-anodized)

Battery hold-down retainer, tall (2) (allows for installation of taller, multi-cell batteries)

LED Light Bar Kit, TRX-4M™ (includes Front Light Bar, Roof Light Bar, Mounts, Hardware) (fits #9711 Or 9712 Bodies)

LED lights, tail lights (red)/ power harness/ tail light housings (left & right)/ tailgate trim (black)/ zip ties (3)

Light Bar, Chrome (housing and Lens Only) (fits #9262 Or 9262X Roll Bar)

Servo horns, steering, long (2), short (2)/ linkage, steering (3x20mm turnbuckle) (2)/ rod ends (short) (4)/ hollow balls (4)

750mAh 7.4V 2-Cell 20C LiPo Battery

Main chassis (gray) (164mm long battery compartment) (fits both flat and hump style battery packs) (use only with #3626R ESC mounting plate)

BL-2s™ Brushless Power System, Waterproof (includes BL-2s™ ESC and BL-2s™ 3300 Motor)

Cooling fan kit (with shroud)/ 2.5x16mm CS (with threadlock) (4) (fits #3483 motor) Lower your Velineon motor’s temperatures with this cooling fan ...

Gearbox housing/ motor plate

Side trim, left & right (chrome)/ retainers/ LED lens/ 2.6x8 BCS (24) (fits #8010 series bodies)

LED lens, arms, front, red (left & right)

Gear set (for 2085 servo)

Servo horn, steering/ linkage, steering (3x30 threaded rod)/ rod ends (2)/ hollow balls (2)

Receiver box cover (for chassis top plate)/ battery cover (mid chassis)

Box, receiver (upper and lower halves)/ clip (1)/ foam pad

Turnbuckles, 116mm (rear toe control links) (2) (includes installed rod ends and hollow ball connectors)

LED lights, front harness (4 clear lights), Summit

Guards, steering servo (2)

Charger, USB, dual-port (high output)

Charger, USB-C, 40W (6 - 7 Cell, 7.2 - 8.4 Volt, NiMH) (with ID®)

Feet, non-skid, LED lens (4)/ landing gear (4)

Charger, AC, 350 mAh (5 cell, NiMH)

LED lights, high/low switch (for #8035 or #8036 LED light kits)

LED light kit, 1/16th Summit (power supply, chrome lightbar, roof light harness (4 clear, 2 red), chassis harness (4 clear, 2 red), wire ties, mounts)

Battery door, DTS-1

Radio tray/ radio tray retainer (2)/ 4x16mm BCS (stainless) (2)

Electronics box, left/ box cover