TRAXXAS

Springs, shock (natural finish) (GTS) (0.45 rate) (2)

Driveshaft assembly, inner (1) (fits front & rear, differential side)

Spring, shock (red) (GTR) (0.314 rate) (1 pair)

Axle shafts, front, outer (2)

Driveshaft assembly, front, extreme heavy duty with 6mm axle (1)/ screw pin (1) (left or right) (fully assembled, ready to install) (for use with #...

Stub axle, aluminum, (green-anodized) (1) (for use only with #7750X or 7896 driveshaft)

Springs, front (progressive, +20% rate, blue) (2)

Housings, differential, rear

Axle carriers, left & right (1 each)

Spur gear, 55-tooth

Bumper, front/ bumper mount, front (pink)

Wheel hubs, 7mm hex (4)/ axle pins (8)

Control box (complete) (EZ-Start® 2)

Axle carriers, left & right (1 each) (use with larger 6x13mm ball bearings)/ bearing adapters (for 6x12mm ball bearings) (2)/ dust boot retaine...

Gear, 23-T pinion (1.0 metric pitch) (fits 5mm shaft)/ set screw (for use only with steel spur gears)

Gear set, center differential (output gears (2)/ spider gears (2)/ spider gear shaft)

Suspension arms, lower, black (left and right, front or rear) (2) (for use with #8995 WideMaxx® suspension kit)

Springs, shock (natural finish) (GT-Maxx®) (1.210 rate) (2)

Bumper, rear/ bumper mount, rear

Bulkhead, front

Differential output yoke assembly, extreme heavy duty (2) (left or right, front or rear) (assembled with external-splined half shaft)/ screw pin (2)

Wheelie bar, black chrome (assembled)/ wheelie bar mount

Skid plate, roof (body)/ 3x12mm CS (4)

Housing, differential (rear)

Half shafts, short (heavy duty) (external-splined (2) & internal-splined (2))/ metal U-joints (4)

Bumper, front/ skidplate, front (black)

Spur gear, 83-tooth (48-pitch) (for models with Torque-Control slipper clutch)

Air filter and pre-filter inserts, foam (high-volume) (3) (pre-oiled, assembled) (use with #5266 filter body) (TRX® 2.5, 2.5R, 3.3)

Drag link, machined 6061-T6 aluminum (orange-anodized)

Springs, front (blue) (2)

Axles (front) (2)

Ball bearings, blue rubber sealed (5x8x2.5mm) (2)

Bumper, rear/ bumper mount, rear (pink)

Coupler, exhaust (siliconee)

Turnbuckle, aluminum (red-anodized), camber link, front, 39mm (1) (assembled w/rod ends)/ hollow balls (2) (See part 3741X for complete camber link...

Stub axle carriers (2)

Turnbuckles, toe link, 55mm (75mm center to center) (2) (assembled with rod ends and hollow balls)

Skidplate, chassis

Toe link, front & rear (molded composite) (red) (4)/ hollow balls (8)

Chassis, charcoal gray

Drag link, machined 6061-T6 aluminum (red-anodized)

Ring gear, differential/ pinion gear, differential (12/47 ratio) (front)

Lower chassis, low CG (blue)