traxxas

Chassis

Lower chassis (gray) (166mm long battery compartment) (fits both flat and hump style battery packs)

Servo saver post/ adjuster nut/ locknut (green-anodized, 6061-T6 aluminum) (1 each)

Half Shaft, External Splined (steel-spline Constant Velocity) (1) (fits #9450R Rear Steel CV Driveshaft) (for Bandit®, Bandit® VXL, Drag Slash®)

Half shaft pro-pack (internal-splined (6)/ external-splined (6) (plastic shafts only)

Driveshaft Assembly, Front, Extreme Heavy Duty with 6mm Axle (1)/ Screw Pin (1) (Left Or Right) (Fully Assembled, Ready to Install)

Driveshaft Assembly, Rear, Extreme Heavy Duty with 6mm Axle (1)/ Screw Pin (1) (Left Or Right) (Fully Assembled, Ready to Install)

Half shaft set, short (plastic parts only) (internal splined half shaft/ external splined half shaft/ rubber boot) (assembled with glued boot) (2 a...

Half shaft, external splined (steel-spline constant-velocity) (1)

Half shaft, internal splined (steel-spline constant-velocity) (1)

Half shafts, center (internal splined, front (2) & internal splined, rear (2)/ external splined (2)/ pin retainer (4)) (plastic parts only)

Half shafts, center front (1), center rear (1) (internal splined half shafts (2)/external splined half shaft) (2))/ metal u-joints (4)

Half shafts, heavy duty (external splined (2)/ internal splined (2))/ metal u-joints (4)

Half shafts, long (heavy duty) (external-splined (2) & internal-splined (2))/ metal U-joints (4)

Half shafts, short (heavy duty) (external-splined (2) & internal-splined (2))/ metal U-joints (4)

Half-shaft pro-pack (internal-splined (6)/external-splined (6)) (plastic shafts only)

Half-shafts (internal-splined (2)/external-splined (2))/ metal U-joints (4)

Hardware kit, complete (contains all hardware used on 1/18-scale TRX-4M™) (includes clear plastic storage container)Give your TRX-4M™ a complete re...

Header, blue-anodized aluminum (for rear exhaust engines only) (TRX® 2.5, 2.5R, 3.3)

Hold down, battery

Hold down, battery (2)/ hold down retainer/ battery post/ angled body clip

Hold down, battery/ hold down retainer/ battery post/ foam spacer/ angled body clip (allows for installation of taller, multi-cell batteries)

Housing, center differential/ x-ring gaskets (2)/ ring gear gasket/ bushings (2)/ 5x10x0.5 TW (2)/ CCS 2.5x8 (4)

Housing, cush drive (front & rear halves)

Housing, differential (front)

Housing, differential (front/rear)

Housing, differential (rear)

Housing, spool / spool shaft/ bushing

Housings, differential, front

Housings, differential, rear

Hub retainer, 17mm hubs, M4 X 0.7 (4) (use with #5853X, #6856X, #6469)

Idler gear, steel (30-tooth)

Input gear, 22-tooth/ input shaft (transmission) (heavy duty) (fits Bandit®, Rustler®, Stampede®, Slash® 2WD)