Shock Springs

Big Bore shocks (short) (hard-anodized & PTFE-coated T6 aluminum) (assembled with TiN shafts w/ springs)(f/r)(2) (Note: Assembled with 32mm sha...

Caps & spring retainers, GTR shock (upper cap (2)/ hollow balls (4)/ bottom cap (2)/ upper retainer (2)/ lower retainer (2))

Caps and spring retainers, GTR long/xx-long shock (upper cap (2)/ hollow balls (4)/ bottom cap (2)/ upper retainer (2)/ lower retainer (2))

Caps and spring retainers, GTR shock (upper cap (2)/ hollow balls (2)/ bottom cap (2)/ upper retainer (2)/ lower retainer (2))

Caps and spring retainers, GTR shock (upper cap (2)/ hollow balls (4)/ bottom cap (2)/ upper retainer (2)/ lower retainer (2))

Clutch shoes (2)/ spring (N. Rustler®/N. Sport®/N. Stampede®)

Clutch shoes (2)/ spring (T-Maxx®/Revo®/Jato®/Nitro 4-Tec®)

Dust boot, throttle (2)/ return spring (TRX® 2.5, 2.5R, 3.3)

Fuel tank rebuild kit (contains cap, foam washer, o-ring, upper/lower retainers, screw, spring and screw pin)

Header spring/ gaskets (TRX® 2.5, 2.5R, 3.3)

Input shaft (slipper shaft) / spring pin

Linkage set, throttle & brake, Revo®/Slayer (includes servo horns, rod guides, brake spring, brake adjustment dial, brake lever, rods (wires), ...

Rebuild kit, fuel tank (includes: mounting post, grommets (2), tank guard, mounting clips (2), cap o-ring, cap o-ring retainer, cap pull ring (2), ...

Rebuild kit, slipper clutch (steel disc (2)/ friction insert (2)/ 4.0mm NL (1)/ spring washers (4), metal washer (1))

Servo horn (with built-in spring and hardware) (for Summit locking differential)

Servo saver spring, heavy duty (for use with metal-gear servos)

Servo saver/ servo saver spring/ servo horn, steering

Shocks, GTM (assembled w/o springs) (2) Replacement part for these models: TRX-4M™ 1/18 Ford® Bronco® TRX-4M™ 1/18 Ford® Bronco® (Model# 97074-1...

Shock caps, GT-Maxx® shocks/ spring perch/ adjusters (2) (for 2 shocks)

Shock caps, GTX shocks/ spring perch/ adjusters/ 2.5x14mm CS (2) (for 2 shocks)

Shocks, GTX, Medium (aluminum, Green-Anodized) (Fully Assembled Without Springs) (2)

Spring Retainer (adjuster), Gray-Anodized Aluminum, GTX Shocks (4) (assembled with O-ring)

Big Bore shocks (xx-long) (hard-anodized & PTFE-coated T6 aluminum) (assembled) with red springs, TiN shafts (8 pack)

Shocks, GTR aluminum (assembled) (2) (without springs)

Gearbox halves (front & rear)/ rubber access plug/ shift detent ball/ spring/ 4mm GS/ shift shaft seal, glued

Rebuild kit (heavy duty), slipper clutch (steel disc/ aluminum friction pads (3)/ spring (1)/ 2x9.8mm pin/ 5x8mm MW/ 5.0mm NL (1)/ 4.0mm NL (1))