TRAXXAS

Wing, Rustler® 4X4 (green)/ 3x8 FCS (3)

Skid plate, roof (body) (green)/ 3x12 CS (4)

Stub axles, front, heavy duty (2)/ yokes (2)/ pins (4)

Shock tower, front

Stub axle assembly, rear, outer, extreme heavy duty (1) (left or right) (assembled with internal-splined half shaft)

Half shafts, heavy duty (external splined (2)/ internal splined (2))/ metal u-joints (4)

Springs, front (progressive, +10% rate, pink) (2)

Cover, gear/ motor wire hold-down clip

Ring gear, differential/ pinion gear, differential (rear)

Drag link, machined 6061-T6 aluminum (green-anodized)

Driveshaft, center, 6061-T6 aluminum (red-anodized)

Driveshaft, center, 6061-T6 aluminum (blue-anodized)

Gear clutch, complete (high stall)

Driveshaft assembly, front, heavy duty (1) (left or right) (fully assembled, ready to install)/ screw pin (1)

Spur gear, 50-tooth (0.8 metric pitch, compatible with 32-pitch) (for Slash 4x4 center differential)

Driveshaft, center, 6061-T6 aluminum (orange-anodized) (189mm)

Gear, 24-T pinion (1.0 metric pitch) (fits 5mm shaft)/ set screw (for use only with steel spur gears)

Gear, 22-T pinion (1.0 metric pitch) (fits 5mm shaft)/ set screw (for use only with steel spur gears)

Gear, 18-T pinion (1.0 metric pitch) (fits 5mm shaft)/ set screw (for use only with steel spur gears)

Body mount (1)/ body mount post (2) (front)

Gear, 17-T pinion (1.0 metric pitch) (fits 5mm shaft)/ set screw (for use only with steel spur gears)

Telemetry trigger magnet holders, spur gear/ magnet, 5x2mm (1)/ 3x8mm CCS (3)/ 3x10mm CCS (3)

Gear, 26-T pinion (1.0 metric pitch) (fits 5mm shaft)/ set screw

Mount, temperature sensor (electric motors)/ wire tie/ thermal pad

Spur gear, 50-tooth (0.8 metric pitch, compatible with 32-pitch)

Spur gear, steel, 50-tooth (0.8 metric pitch, compatible with 32-pitch) (for center differential)

Wheelie bar

Gear set, differential (spider gears (4)/ spider gear shaft (2))

Gear, 15-T pinion (1.0 metric pitch) (fits 5mm shaft)/ set screw (for use only with steel spur gears)

Gear, 12-T pinion (1.0 metric pitch) (fits 5mm shaft)/ set screw (for use only with steel spur gears)

Gear, 15-T pinion (machined) (1.0 metric pitch) (fits 5mm shaft)/ set screw (for use only with steel spur gears)