TRAXXAS

Skidplate, center/ 4x20 CCS (4)/ 3x10 CS (4) (fits Maxx® with extended chassis (352mm wheelbase))

Air filter body (high volume)/ filter support/ cap/ foam filter, pre-filter/ air filter base/ wire mount/ hardware (1 each)

Battery hold-down/ battery compartment spacers/ foam pads

Driveshaft assembly, front & rear, 6061-T6 aluminum (blue-anodized) (2)

Driveshaft assembly, rear, heavy duty (1) (left or right) (fully assembled, ready to install)/ screw pin (1)

Chassis

Housing, differential (front)

Wheels, 1.0" (chrome) (2)

Suspension arms, upper (left & right) (satin black chrome-plated) (assembled with hollow balls)

Suspension arms, upper (left & right) (assembled with hollow balls)

Body, GTX shock, medium (hard-anodized, PTFE-coated aluminum) (1)

Cone, split beveled

Suspension arms, upper, blue (left or right, front or rear) (2)

Connector, 25.2 volt to 14.8 volt jumper (allows a Traxxas® dual-battery 25.2 ESC to run on a single 14.8V battery pack)

Carriers, Stub Axle, Rear, Extreme Heavy Duty, Blue (Left and Right)/ 3x41mm Hinge Pins (2)/ 3x20mm BCS (2) (for Use with #9080 Upgrade Kit)

Bulkhead, rear (upper and lower)

Bulkhead (front) (black)

Heat sink, Titan® 87T motor (6061-T6 aluminum, green-anodized)

Cover, Gear (gray-Anodized 6061-T6 Aluminum)

Fenders, Inner, Front and Rear (for Clipless Body Mounting) (2 Each)/ Rock Light Covers (8)

Ring gear, differential/ pinion gear, differential

Body Conversion Kit, Slash 2WD (includes Front and Rear Body Mounts, Latches, Hardware) (for Clipless Mounting)

Rod ends (4) (assembled with steel pivot balls) (replacement ends for #7748G, 7748R, 7748X, 8542A, 8542R, 8542T, 8542X)

Hardware Kit, E-Revo® VXL (contains All Hardware Used on E-Revo® VXL)

Hardware Kit, X-Maxx® (contains All Hardware Used on X-Maxx®)

Wheels, 2.2" (graphite gray, satin chrome beadlock) (2) (Bandit® front)

Hardware Kit, Maxx® (contains All Hardware Used on Maxx®)