TRAXXAS

Wheelie bar, black (assembled)/ 3x20 CS (8)

Bumper mount, rear Rear bumper mount Replacement part for these models: XRT®: TQi™ Traxxas Link™ Enabled 2.4GHz Radio & TSM® (Model# 78086-4)

Spur gear, 46-tooth, steel (1.0 metric pitch)

Suspension arm, front (right), green

Camber links, front (TUBES green-anodized, 7075-T6 aluminum, stronger than titanium) (2) (assembled with rod ends and hollow balls)/ aluminum wrenc...

Suspension arm, rear (left), green

Suspension arm covers, green, rear (left and right)/ 2.5x8 CCS (12)

Servo Mount/ Bulkhead Cover/ Chassis Brace/ Steering Cover/ 3x12mm CS (2)/ 3x8mm CS (2)

Servo horn, steering/ linkage, steering (48mm, assembled with pivot balls)

Lower chassis (gray) (166mm long battery compartment) (fits both flat and hump style battery packs)

Camber links, rear (TUBES blue-anodized, 7075-T6 aluminum, stronger than titanium) (2) (assembled with rod ends and hollow balls)/ aluminum wrench (1)

Trailer hitch (assembled)/ trailer coupler/ 3mm spring pre-load spacers (2)/ 2.5x8mm BCS (2)/ 1.6x10mm BCS (self-tapping) (1)

Wing, orange/ 4x12mm FCS (4)

Bumper, front/ bumper mount/ 4x12 CCS (2)/ 4x22 BCS (2)/ 3x12 BCS (2) (fits 2WD Stampede®) (for LED light kit installation)

Caster blocks (c-hub), left & right/ kingpin bushings (4)

Bumper, front/ skidplate, front/ tie bar mount, front/ 3x25 CS (2)

Battery, RX Power Pack (5-cell flat style, NiMH, 1200mAh)

Camber links, rear (TUBES charcoal gray-anodized, 7075-T6 aluminum, stronger than titanium) (2) (assembled with rod ends and hollow balls)/ aluminu...

Chassis

Windows, body (fits #9712 body)

Suspension link set, complete (front & rear) (includes steering link (1), front lower links (2), front upper links (2), rear links (4)) (assemb...

Skidplate, center/ bumper mount, front/ bumper mount, rear

TRX-4M Utility Trailer Stake Side PanelsStake side panels are a great way to increase the hauling capacity of your TRX-4M™ Utility Trailer with a f...

Fuel canisters (left & right)/ jack (red) (fits #9712 body)

Axle, front (assembled)/ M2.5x0.45 NL (2)

Battery hold-down/ mounts (front & rear)/ battery compartment spacers/ foam pads (fits Maxx® with extended chassis (352mm wheelbase)) Battery h...

Driveshaft, rear (shaft only, 5mm x 131mm) (1) (for use only with #9554 stub axle)

Driveshaft assembly, rear, extreme heavy duty with 6mm axle (1)/ screw pin (1) (left or right) (fully assembled, ready to install) (for use with #9...

Axle shaft, front (hardened steel) (1)

LED lenses, body, front & rear (complete set) (fits #9711 body)

Hold down, battery

Toe links, front (120mm) (2) (assembled with hollow balls)